Zektor DVS5.1 Manuale del Proprietario

ZEKTORDVS5.1DVI Video / Audio SwitchOwner’s Manualwww.zektor.comRev: 2 01/19/05TM

10Learning New Remote CodesTeaching the DVS5.1 to use learned remote control keysIf your remote does not have one of the pre-programmed component code

11STEP 4 4 The Power indicator blinks slowly, and input 2 is selected.Press the key on your remote that you want to use as the new key for SELECTIN2.1

12STEP 11 11 After a pause, the Power indicator blinks 5 times, and repeats.Press the key on your remote that you want to use as the new key for SELEC

13Bright / Dim / Auto-dimming ModesSetting the Display intensity modes of the DVS5.1The front panel display of the DVS5.1 can be set to Bright, Dim or

14Setting Power On DefaultsThe DVS5.1 power on default modeWhen toggling between Standby mode and PowerOn, the DVS5.1 will remember all it’s current s

15Restoring the DVS5.1 to Factory DefaultsRestoring the DVS5.1 to the factory defaultsResetting the DVS5.1 to the factory defaults is done by removing

16Typical ApplicationThe above example shows DVS5.1 setup to select between 5 different DVI devices.The DVI output is connected to a DLP projector, an

17Typical Applications (Cont’d)Some Notes on DVI Cable LengthsDVI cables vary greatly in quality, and as a result, the maximum length of the DVI cable

18

19Warranty InformationWarranty PolicyZEKTOR, LLC warrants this product against defects in material and workmanship under normal use and service for on

2Important Safety Instructions!Read all instructions for prior to installation of your product.Retain this User's Manual for future reference.Adh

20Customer Service Contact InformationZEKTOR, LLC12675 Danielson CourtSuite 401Poway, CA 92064Phone: (858) 748-8250Email: [email protected]

3Table of ContentsImportant Safety Instructions! . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Table of Content

4A DVS5.1 OverviewA Description of the DVS5.1The DVS5.1 is a 5 input, Digital Audio / DVI video switch. Channel selection can be done using front pane

5Front Panel OperationsOperating the DVS5.1 is straight forward and is simply a matter of plugging the DVS5.1’s power supply into an available A.C. ou

6Using the DVS5.1 with a Remote ControlRemote operations of the DVS5.1 are accomplished through the use of just about any remote con-trol. A remote co

7Programming your Remote ControlSetting up your Universal Remote ControlFor remote control operations, the DVS5.1 requires either a universal remote c

8Using Alternate Remote CodesUsing Alternate Component Keys on your RemoteThe DVS5.1 will also respond to alternate component key codes. Allowing you

9STEP 1 1 Place the DVS5.1 in standby mode by pressing the power button if needed. At this point only the power indicator should be glowing red.STEP 2